Eco Glass Fibre 265g is a high-quality PVC-free glass textile wallpaper made from woven glass fibers that are robust and long-lasting. It has a special inkjet receptive coating, which offers a high colour gamut. Due to its scratch resistant surface,it is suitable for long-term use in medium-to-high traffic areas. The material is fire retardant and allows a wall to breathe which prevents the appearance of mold or mildew, making it the perfect solution for new installations or humid areas.
Fire retardancy
Reaction-to-fire: B – s1, d0 in accordance with EN13501-1:2018
Class “A” in accordance with ASTM E84-21a
Washability
Scrubbable, in accordance with EN259-2 / EN12956
Sustainability
Free of PVC
REACH compliant
CE-marking in accordance with EN15102:2019
Application
These instructions have been specifically designed for installing Glass Fibre wall coverings in wet areas or environments in direct contact with water, such as shower cabins or even outdoor spaces.
Recommended Adhesives
– Recommended adhesive: MAPEI Ultrabond Eco Décor Wet Adhesive
– Recommended protective coating: MAPEI Mapecoat Décor Protection
Wall Preparation
1. Ensure that the wall is level, clean, smooth, and completely dry.
2. To smooth an existing shower wall during renovation, such as in the case of old ceramic tiles, the joints must first be filled with a smoothing compound. We recommend applying the ready-to-use smoothing compound MAPEI Planiprep 4 LVT or MAPEI Planiprep Contract. This cementitious smoothing compound has been specially developed for use in wet areas and on non-absorbent substrates. Other brands are available on the market – seek specialized advice at your local hardware store.
Adhesive Application
3. Inspect the wall, check the material, and decide where to start.
4. Apply MAPEI Ultrabond Eco Décor Wet Adhesive to the wall surface using a suitable smooth spatula. This is a special adhesive for decorative wall coverings in glass fibre and vinyl in wet areas.
Wall Covering Installation
5. Position and place the printed and dry wallpaper panels side by side without overlapping, using a wallpaper spatula and aligning the graphics perfectly.
6. Close the seams with the spatula in a vertical direction and remove any excess adhesive, taking care not to damage the printed graphics. Any small halos caused by the presence of adhesive will later be covered with the protective coating in the following steps.
7. Remove excess panels using a sharp spatula. Always move the spatula while keeping the blade in cutting motion.
Application of Waterproof Protective Layer
8. Approximately two hours after installing the wallpaper, apply a cross-coat of the two-component protective finish MAPEI Mapecoat Décor Protection with a short-pile roller. The product must be used within two hours after mixing.
Use a waterproof silicone sealant to finish all corners and seams.
Cleaning and Maintenance
9. After the protective resin has been applied and the wall covering is completely dry, it can be cleaned with mild soap. For more persistent dirt, similar cleaning solvents can be used. Do not use acids, as they may compromise the protective layer applied in step 8.
Develop a wall surface based on your own images, artwork or design references, and adapt it to the specific requirements of your project. From concept to production, each wallpaper is prepared to fit your dimensions and delivered ready for application.
Follow the steps and receive a project-ready solution, produced with precision and material quality.
